Assembly instruction for the Standard TX900P package using an external'Panel' antennae.
This kit tends to be used when there is a mobile signal strength of at least two bars outside the house on three sides but very little or no signal inside the building also this kit and all others have Full CE Approval and carry 12 months warranty.
The panel antenna is positioned towards the top left hand corner of the picture. It is supplied with screws and rawl-plugs such that it is an easy job to mount it on the wall facing the best signal. It doesn't need to be mounted at extreme height but it is wise to put it out of the reach of children and animals.
It is important to position the panel aerial on the wall outside of which the best signal can be achieved. The whole effectiveness of the installation revolves around the correct fitting and, to an extent, the directionality of the external antennae.
Cable from the Panel aerial comes down the side of the building before going through the wall and being attached directly into the top of the TX900 unit.
If you require custom cable lengths contact us via Email/Phone for a custom quote.
If you are using an aerial contractor, then that person will also drill the access hole in the wall that the cable needs. If doing it yourself, a suitable drill and long drill bit can be hired from your local tool-hire center. Don't forget to seal the hole after the aerial cable has been passed through and a tube of suitable sealant can usually be found at the tool-center as well.
The main processor, the TX900 unit, is attached to the inside of the wall using its mounting plate that has previously been attached to the wall using Rawl-plugs. The aerial able is attached to the top of the TX900 unit, the power cable is plugged into the side of the TX900 and the system is switched on and communication is restored.
Do bear in mind that all mobile phone users in the building need to be using the same group of providers so as to achieve total connectivity for everyone.
The picture below shows how the TX900P kits goes together.
NB. Please check the rules in your jurisdiction relating to signal repeating devices. For internal use only. Mob Dev cannot be held responsible for improper use of these devices
